Creates a 3D solid wedge.
Summary
The direction of the taper is always in the positive X-axis direction of the UCS.
Entering a positive value draws the height along the positive Z axis of the current UCS. Entering a negative value draws the height along the negative Z axis.
List of Prompts
The following prompts are displayed.
-
First corner
-
Sets the first corner of the wedge base.
-
Other corner
-
Sets the opposite corner of the wedge base, located on the X,Y plane.
-
Center
-
Creates the wedge by using a specified center point.
-
Cube
-
Creates a wedge with sides of equal length.
-
Length
-
Creates a wedge with length, width, and height values you specify. The length corresponds to the X axis, the width to the Y axis, and the height to the Z axis. If you pick a point to specify the length, you also specify the rotation in the XY plane.
-
Height
-
Sets the height of the wedge. Enter a positive value to draw the height along the positive Z axis of the current UCS. Enter a negative value to draw the height along the negative Z axis
-
2Point (height)
-
Defines the height of the wedge by specifying the distance between two points
