Share

To Work With Creating Mesh Wedges

Product Documentation
Intermediate
View Original

Create a Mesh Wedge Based on Diagonal and Height

  1. Click Mesh Modeling tabPrimitives panelMesh Wedge.At the Command prompt, enter MESH. Then enter w (Wedge).
  2. Specify the first corner of the base.
  3. Specify the opposite corner of the base.
  4. Specify the height of the wedge.

Create a Mesh Wedge Based on Length, Width, and Height

  1. Click Mesh Modeling tabPrimitives panelMesh Wedge.At the Command prompt, enter MESH. Then enter w (Wedge).
  2. Specify the first corner of the base.
  3. At the Command prompt, enter L (Length). Specify the length of the base.
  4. Specify the width of the base.
  5. Specify the height of the wedge.

Create a Mesh Wedge With Equal Length, Width, and Height

  1. Click Mesh Modeling tabPrimitives panelMesh Wedge.At the Command prompt, enter MESH. Then enter w (Wedge).
  2. Specify the first corner or enter c (Center) to set the center point of the base.
  3. At the Command prompt, enter c (Cube). Specify the length of the wedge and a rotation angle.

    The length value sets both the width and height of the wedge.

Create a Mesh Wedge Based on a Center Point, Corner of Base, and Height

  1. Click Mesh Modeling tabPrimitives panelMesh Wedge.At the Command prompt, enter MESH. Then enter w (Wedge).
  2. At the Command prompt, enter c (Center). Specify the center point of the base.
  3. To set the location of a corner of the base, use one of the following methods:
    • To set the length and width simultaneously: Specify the location of one corner of the base.
    • To set the length and width separately: At the Command prompt, enter L (Length) and specify the length. Then specify the width.
  4. Specify the height of the wedge.

Related References

Related Concepts

Was this information helpful?