Places a hole at a specified distance from 2 contour lines.
Find
Summary
You typically use this command to draw a hole in a corner. If required, you can choose to draw a centerline cross only.
List of Prompts
The following prompts are displayed.
- Dialog box
- Displays the Centerlines dialog box, using which you can change the centerline creation method.
- First contour line
- Selects the first of two lines required to define a corner.
- Second contour line
- Selects the second of two lines required to define a corner.
- Offset from first contour line
- Specifies the distance from the first line to the center of the hole to draw.
- Offset from second contour line
- Specifies the distance from the second line to the center of the hole to draw.
- Diameter of hole
- Specifies the diameter of the holes to draw on the pitch circle. Enter S to specify that you want to select the hole from the standard part content library. Specify "No hole" to create centerline crosses without the holes.
- Centerline cross diameter
- Specify the diameter of the centerline cross to place on the hole.