Inserts a seal or O-ring and draws the corresponding groove on a shaft.
Find
Summary
You can place seals on the outer contour of a shaft or place O rings on the shaft, inside a hollow shaft, or on the plane surfaces of a shaft. A wizard enables you to select the type of seal/O-ring and the view to insert. If the system cannot find a seal/O-ring to fit the shaft, you can select a size from a list of available sizes and resize the shaft to fit.
Use the Select a Shaft Seal dialog box to select the type and the view to insert.
List of Prompts
The following prompts are displayed:
- Insertion Point
- Specifies a point on a shaft contour to insert the groove.
- Centerline
- Specifies the centerline around which the command draws the groove and O ring or seal.