To Chamfer a Wall Endcap Component

Use this procedure to modify a wall endcap by chamfering a wall component corner.

1. Select the wall segment with the wall endcap to modify.
2. Click Wall tabEndcap panelEndcap Edit In Place.
3. Select the component that has the corner you want to chamfer.

   You may only chamfer the corner of one component at a time. Press Esc to clear component selection.

4. Click Edit In Place tabModify panelChamfer.
5. Specify the chamfer distances.
6. Select the first component edge to chamfer.
7. Select the second component edge to chamfer.
8. Exit the edit-in-place session:

   If you want to...	Then...
   Save any changes you made during the edit-in-place session as a new style	click Edit In Place tabEdits panelSave As.
   Discard any changes you made during the edit-in-place session	click Edit In Place tabEdits panelCancel.
   Save any changes you made during the edit-in-place session	click Edit In Place tabEdits panelFinish.

   In the following example, a CMU component corner is chamfered.