Adds a conduit.
The following prompts are displayed.
- Start point
-
Specify the starting point to insert the conduit segment.
- Routing Preference
-
Specifies the routing preference of the conduit. This is used to draw accurate runs in auto layout (based on the connection type).
- System
-
Specifies the system and its abbreviations for the part. This may determine the layer placement.
- Size
-
Specifies the dimension, based on the outside and inside diameters of the conduit (as shown). Nominal size (also referred to as trade size) complies with industry standards.
- Lock Size
-
Specify whether or not to lock the nominal size of an existing pipe or fitting. (Unlocked by default).
- Elevation
-
Specify the elevation above or below the XY plane of the object.
- Justification
-
Specify the justification setting for a conduit segment.
- Compass
-
Specify whether to enable or disable the compass.
- Plane
-
A 3D surface or 2D line that can be used as a reference to constrain or offset the conduit run, when it is difficult to place geometry parametrically.
- Rotate
-
Specify the fitting routing angle.
- Slope
-
Specify pitch of the drawn segment.
- Match
-
Specify conduit to match.
- New run
-
Ends the current duct run and start a new duct run.
- Preferences
-
Opens the conduit layout preferences.
- Undo
-
Undoes the previous action.