Adds wire.
Using this command, you can add wires using different wire segment type.
The following prompts are displayed.
- Start point
-
Specify the starting point.
- System
-
Specify the system name.
- Style
-
Specify the style name.
- Line
-
Draw wires using straight lines.
- Arc
-
Specify the value for height and offset to draw wires with arc.
- Spline
-
Specify the value for height and offset to draw wires with curves that pass through or near a set of specified points.
- Snake
-
Specify the value for height and offset to draw wire with snake.
- Polyline
-
Specify radius to set the curvature for the fillets to draw wires with lines connected with filleted corners.
- Chamfer
-
Specify the value for height and offset to draw wires with plateaus.
- Device
-
Specify a device.
- Match
-
Specify wire to match.
- Generate
-
Generates wires between all the devices assigned to the specified circuit.