Creates one or more conduit runs parallel to a baseline pipe run as you draw it.
Using this command, you can create additional instances of the previously created wire and edit its properties.
The following prompts are displayed.
- Select baseline object
-
Specify the baseline pipe.
- Select parallel pipes
-
Specify the parallel conduit segment.
- Next point
-
Specify next points in the run.
- Size
-
Specify the nominal size of the pipe.
- Lock Size
-
Specify whether or not to lock the nominal size of an existing pipe or fitting. (Unlocked by default).
- Tolerance
-
Specify the value for height and offset to draw wires with arc.
- Elevation
-
Specify the absolute or relative elevation of the pipe.
- Justification
-
Specify orientation to justify the pipe object.
- Compass
-
Specify whether to enable or disable the compass.
- Plane
-
A 3D surface or 2D line that can be used as a reference to constrain or offset the conduit run, when it is difficult to place geometry parametrically.
- Rotate
-
Specify the rotation for the angle.
- Match
-
Specify pipe to match.
- Switch baseline
-
Specify a new baseline.
- Preferences
-
Opens pipe layout preferences.