Use this dialog box to select the profiles and specify station ranges for a profile incremental station report.
This report lists PVI stations and elevations of the selected profile at regular intervals, at critical geometry points, and crest and sag curve points.
List of Profiles
- Include
-
Specifies the profiles to include in the report. Select a check box to include the profile.
- Name & Description
-
Displays the name and description of the profiles in the drawing.
- Station Start & Station End
-
Displays the start and end stations for a selected profile.
You can edit these values by highlighting a profile in the list and adjusting the Report Settings (see below).
- Alignment
-
Displays the horizontal alignment that the profile is associated with.
Report Settings
- Start Station & End Station
-
Displays the start and end stations for a highlighted profile. Click a profile name in the list to highlight it.
You can edit these values to change the range of stations included in the report. You can enter formatted or unformatted values, such as 2+50.95 or 250.95.
- Station Increment
-
Specifies the station increment to use. For example, specify 50 to report at increments of 50 feet or meters along the profile.
Note: The start and end stations are always included in the report. The increment starts at the beginning station, even if it is an odd value. The increment is applied to all profiles. - Save Report To
-
Specifies the name and location of the resulting report.
- Create Report
-
Generates the report and saves it to the specified location.
- Done
-
Closes the dialog box and discards changes to station ranges.