Share

Editing Subdivided Parcels

Product Documentation
Intermediate
View Original

Use the Slide Line and Swing Line edit commands to edit subdivided parcels.

You can use the Slide Line and Swing Line edit commands to edit attached lot lines. Attached lot lines are parcel segments that were created with the Parcel Layout Tools subdivision commands.

Using layout tools is the only activity possible while the Parcel Layout Tools toolbar is open.

Tutorial: Editing Parcel Data

To edit parcels by subdividing with Slide Line - Edit command

  1. Click Home tabCreate Design panelParcel drop-downParcel Creation Tools .At the Command prompt, enter CreateParcelByLayout.
  2. Click for the Slide Line - Edit tool.
  3. In the Create Parcels - Layout dialog box, adjust default settings and press OK.
  4. Select the attached lot line to adjust.
  5. Click inside the parcel to be edited.
  6. Click the start point on the parcel frontage.
  7. Click an end point along the frontage. A preview graphic highlights the proposed frontage.

    Specify the angle, bearing or azimuth to edit the lot line. Preview graphics display if a solution can be obtained.

    Note

    When prompted for the angle, bearing or azimuth, you can press Enter to enter a 90 degree angle as this is the default angle.

  8. Accept the result to edit the parcel. If a solution based on the current parcel sizing parameter values is not found, you are prompted to adjust the parameters or reenter a new value for the method you are using.
  9. When you finish editing parcels, press Esc to close the toolbar. (If one of the layout tools is still in use, press Esc twice.)

To edit parcels by subdividing with Swing Line - Edit command

  1. Click Home tabCreate Design panelParcel drop-downParcel Creation Tools .At the Command prompt, enter CreateParcelByLayout.
  2. Click for the Swing Line - Edit tool.
  3. In the Create Parcels - Layout dialog box, adjust default settings and press OK.
  4. Select the attached lot line to adjust.
  5. Click inside the parcel to be edited.
  6. Click the start point on the parcel frontage.
  7. Click an end point along the frontage. A preview graphic highlights the proposed frontage.
    Note

    OSNAP must be turned off when using the Swing Line commands.

  8. Specify the swing point. Preview graphics display if a solution can be obtained.
  9. Accept the result to edit the parcel. If a solution based on the current parcel sizing parameters values is not found, you are prompted to adjust the parameters or reenter a new value for the method you are using.
  10. When you finish editing parcels, press Esc to close the toolbar. (If one of the layout tools is still in use, press Esc twice.)

Ribbon

Home tab Create Design panel Parcel drop-down Parcel Creation Tools

Menu

Parcels menuEdit ParcelEdit Parcel Segments

Command Line

CreateParcelByLayout

EditParcel

Parcel Layout Tools

Slide Line - Edit

Swing Line - Edit

Dialog Box

Parcel Layout Tools


Was this information helpful?