Use the point editing utilities to change multiple drawing points using a single command.
You cannot use the point editing utilities to edit project points directly. To edit project points, you must check the points out to a drawing, modify them, and then check them back in to the project. For information about a recommended procedure for checking out and changing a large number of project points, see Modifying A Large Number of Project Points.
Topics in this section
- Changing the Elevations of Points
Use the Datum command to change the elevations of selected drawing points.
- Changing the Elevations of Points Based on a Surface
Change the elevations of a point, point group, or a selection of drawing points based on the elevations in a selected surface.
- Renumbering Points
Use the Renumber command to assign new point numbers to selected drawing points.