Add a fixed curve defined by specified start and end points and a direction at the end point.
The result is a three-point curve. The specified curve direction (3) determines the location of the pass-through point between the start (1) and end (2) points.
Tip
You can use transparent commands when you are prompted to specify direction, radius, or length, or use station offsets to specify any points. For more information, see Transparent Commands.
To add a fixed curve (two points and a direction at second point)
- Click the alignment. Click Alignment tab
Modify panelGeometry Editor
. - On the Alignment Layout Tools toolbar, click
Fixed Curve (Two Points And Direction At Second Point). - Specify the start point.
- Specify the next point. A preview of the curve is displayed.
- Specify the direction at the second point or specify a bearing or azimuth.