Share

Adding a Corridor Region Using the Section Editor Ribbon

Product Documentation
Intermediate
View Original

Create a corridor region using the tools on the Section Editor ribbon tab.

Specify a baseline and a start and end station, and then create a new corridor region.

To add a corridor region using the Section Editor ribbon

  1. In Toolspace, on the Prospector tab, expand the Corridors collection. Select the corridor. Right-click. Click Corridor Section Editor.
  2. On the Section Editor tabStation Selection panel, select a station that does not have a region associated with it.

    In the Select a Station list, and indicate that a station is not associated with a region.

  3. Click Section Editor tabCorridor Edit Tools panelAdd a Region.
  4. Do one of the following:
    • Specify the region start and end stations.
    • Enter F to fill an entire gap area as a new region.
  5. In the Create Corridor Region Dialog Box, specify a name and an assembly for the new region. Click OK.
  6. In the Target Mapping Dialog Box, set the surface, offset, and elevation targets in the corresponding Object Name fields.

    For more information, see Setting Targets.

  7. Click OK to close the Target Mapping dialog box.

Was this information helpful?