Share

Adding a Fixed Curve with a Center Point and Through Point

Product Documentation
Intermediate
View Original

Add a full, fixed circle defined by a specified center point, direction, and pass-through point.

The result is a circle with four pass-through points. The entity position is not affected by edits to adjacent entities.

Tip

You can use transparent commands when you are prompted to specify direction, radius, or length, or use station offsets to specify any points. For more information, see Transparent Commands.

To add a fixed curve (center point, through point)

  1. Click the alignment. Click Alignment tabModify panelGeometry Editor.
  2. On the Alignment Layout Tools toolbar, click Fixed Curve (Center Point, Through Point).
  3. Specify the center point.
  4. Specify the curve direction: either clockwise or counter-clockwise.
  5. Specify a pass-through point. A preview of the curve is displayed.
Tip

Edit the curve by moving the center point or the pass-through point.

Ribbon

Click the alignment. Click Alignment tab Modify panel Geometry Editor

Menu

Alignments menuEdit Alignment Geometry

Command Line

EditAlignment

Alignment Layout Tools Toolbar icons

Fixed Curve (Center Point, Through Point)


Was this information helpful?