Specify a new assembly to use in an existing corridor region.
When a corridor region assembly is changed, targets are maintained if:
- The new assembly has the same subassembly types as the original assembly.
- The left and right sides of the new assembly are identical to the original assembly.
The following procedures describe how to use these tools:
Apply the preview assembly to the current corridor region.
The preview assembly is indicated by a green triangle in Prospector:
- If a region exists at the current location, the preview assembly is applied, and the existing targets are maintained if the preview assembly uses the same subassembly types as the original assembly.
- If no region exists at the current location, then a region is created using the preview assembly.
Exit preview mode without applying the preview assembly.
This command discards the preview assembly.
Change targets for the preview assembly before applying the preview assembly to the corridor region.
This button displays the Target Mapping dialog box, where you can set and edit the targets for the subassemblies.
Topics in this section
- Changing a Corridor Region Assembly by Dragging and Dropping from a Tool Palette or Catalog
Change the assembly used in a corridor region by dragging an assembly from a Tool Palette or Catalog into Section Editor.
- Changing a Corridor Region Assembly Using the Section Editor Ribbon
Change the assembly used in a corridor region using the tools on the Section Editor ribbon tab.
- Changing a Corridor Region Assembly by Selecting an Assembly from Prospector
Change the assembly used in a corridor region by selecting an assembly from the Assemblies collection on the Prospector tab.