In this case, the inside lane slope direction is going towards the crown.
The parameters in the following table must be set as shown for each corresponding LaneSuperelevationAOR subassembly. The other lane subassembly parameters do not affect the axis of rotation pivot points.
NoteThe Mirror Subassemblies command does not affect the Use Superelevation, Slope Direction, Inside Point Code, and Outside Point Code parameters. These parameters must be set manually after a subassembly has been mirrored.
| 1 | 2 | 3 | 4 | |
|---|---|---|---|---|
| Use Superelevation | Left Lane Outside | Left Lane Inside | Right Lane Inside | Right Lane Outside |
| Slope Direction | Away from Crown | Towards Crown | Towards Crown | Away from Crown |
| Potential Pivot | Yes | Yes | Yes | Yes |
| Inside Point Code | Crown | Edge of Pavement (ETW) | Edge of Pavement (ETW) | Crown |
| Outside Point Code | Edge of Pavement (ETW) | Crown | Crown | Edge of Pavement (ETW) |