You can specify a point location by referencing the name of an existing point.
The system searches first in the active drawing, and then in the project, if applicable.
A transparent command can only be used within a running command.
Use the Prompt For Point Names setting to control whether points are created with point names. For more information, see Editing the Default Point Creation Settings.
To specify a point location by point name
- When you are prompted to enter a point in a command, do one of the following:
- Enter 'pa.
- Activate the Transparent Commands toolbar and select
.
- Enter a point name.
- If you are prompted, enter an elevation.
If the point you specified in the previous step has an elevation, it is listed as the default elevation, and you can select it by pressing Enter. For more information, see Entering an Elevation for a Transparent Command.
NoteElevation prompting for transparent commands is controlled by the Transparent Command setting Prompt For 3D Points. For more information, see Transparent Command Settings.
