You can use transparent commands within a main command that requires the entry of multiple point locations.
When you enter a transparent command within a running command that accepts more than one point location (for example, the AutoCAD LINE command), you can enter a series of points in the same format without having to re-enter the transparent command. At any time, you can press Esc to terminate the transparent command and return control to the main command, where you can switch to another transparent command. Also, you can end the transparent command by terminating the main command.
Using Previously Entered Points in a Running Command for Relative Data Input
When you use a transparent command that requires baseline data from which to calculate a relative location, you must enter the required data before specifying the command parameters. If you use a transparent command within a running command, the transparent command remembers the last points entered during the running command and uses them to calculate new relative locations.
For example, when you use the Bearing Distance (‘BD) transparent command, you must first identify a baseline point from which the bearing and distance are measured. If you initiate the Bearing Distance command before you enter any points, you are prompted for the baseline point before you are prompted for quadrant, bearing, and distance. If you use the Bearing Distance command after you have entered at least one point, the last point you entered is used as the baseline.
Transparent Command Point Filters
When you are working within a transparent command and you are prompted to specify a point location, you can use point filters to specify known point information by doing one of the following:
- Entering a point number
- Entering northing and easting
- Selecting a point in a drawing
For more information, see Using Point Filters Within Transparent Commands.