Adding a Corridor Region by Selecting an Assembly from Prospector

To add a corridor region by selecting an assembly from Prospector

1. In Toolspace, on the Prospector tab, expand the Corridors collection. Select the corridor. Right-click. Click Corridor Section Editor.
2. On the Section Editor tabStation Selection panel, select a station that does not have a region associated with it.

   In the Select a Station list, and indicate that a station is not associated with a region.

3. In Toolspace, on the Prospector tab, expand the Assemblies collection. Select the assembly. Right-click. Click Preview in Section Editor.
4. Click Section Editor tabPreview panelEdit Preview Targets.
5. In the Target Mapping Dialog Box, set the surface, offset, and elevation targets in the corresponding Object Name fields.

   For more information, see Setting Targets.

6. Click OK to close the Target Mapping dialog box.
7. Click Section Editor tabPreview panelApply.
   NoteCancel discards the preview assembly.
8. Do one of the following:
   • Specify the region start and end stations.
   • Enter F to fill an entire gap area as a new region.
9. In the Create Corridor Region Dialog Box, specify a name for the new region. The preview assembly is shown in the Assembly field, or you may select another region from the drawing. Click OK.