You can edit the elevation of a feature line using the Grading Elevation Editor, the command line, or several different tools on the Edit Elevations panel.
You can use many of these commands on objects other than feature lines. See the Quick Reference tab of each topic for a list of supported objects for each command.
Tutorial Exercise: Editing the Grading Elevation
Topics in this section
- Quickly Editing Feature Line Elevations
Use the Quick Elevation Edit command to interactively edit the elevation or grade of any feature line or parcel line in a specified site.
- Editing Feature Lines with the Grading Elevation Editor
Edit the vertex elevations of feature lines, survey figures, and parcel lines with the Grading Elevation Editor.
- Editing Feature Line Elevations at the Command Line
Edits the vertex elevations of a survey figure, parcel line, or 3D polyline at the Command prompt.
- Setting a Grade or Slope Between Points
Use to edit the grade/slope between two vertices on a feature line, survey figure, parcel line, or 3D polyline
- Setting Feature Line Elevation by Reference
Sets a vertex elevation on a feature line, survey figure, parcel line, or 3D polyline at a given grade/slope from a specified location.
- Raising or Lowering Feature Line Elevation by Reference
Use the Raise/Lower By Reference command to raise or lower a feature line, based on a grade, slope or relative elevation from a reference point.
- Setting Adjacent Feature Line Elevations by Reference
Use the Adjacent Elevations By Reference command to set the elevations along a feature line, survey figure, lot line or 3D polyline, based on a grade, slope or elevation difference from points along another feature line.
- Extending a Grading By Reference
Use the Grade Extension By Reference command to edit an elevation by extending the grade of a segment on another feature.
- Raising or Lowering Feature Lines
Use the Raise/Lower command to raise or lower the elevation for a selection of feature lines, figures, lot lines, polylines or 3d polylines.
- Inserting a Feature Line Elevation Point
Use the Insert Elevation Point command to insert an elevation point on a feature line.
- Deleting a Feature Line Elevation Point
Use the Delete Elevation Point command to delete an elevation point .
- Inserting a High or Low Elevation Point
Inserts a high or low elevation point onto a feature line, survey figure, parcel line, or 3D polyline.
- Setting Feature Line Elevations from a Surface
Use the Elevations From Surface command to assign the elevations of a surface to the geometry points of one or more feature lines, parcel lines, survey figures, or 3D polylines.