Share

Using Northing and Easting to Specify a Point Location

Product Documentation
Intermediate
View Original

You can specify a point location using known northing and easting values.

A transparent command can only be used within a running command.

To specify a point location by northing and easting

  1. When you are prompted to enter a point in a command, do one of the following:
    • Enter 'ne.
    • Activate the Transparent Commands toolbar and select .
  2. Enter a northing value.
  3. Enter an easting value.
    Note

    The order in which you are prompted for northing and easting is controlled by the Transparent Command setting Prompt For Easting Then Northing. For more information, see Transparent Command Settings.

  4. If you are prompted, enter an elevation. For more information, see Entering an Elevation for a Transparent Command.
    Note

    Elevation prompting for transparent commands is controlled by the Transparent Command setting Prompt For 3D Points. For more information, see Transparent Command Settings.

Command Line

‘NE

Toolbar

Transparent Commands toolbar


Was this information helpful?