Inserting Logos for Real-Time Output

Important: With Flame Family 2023, VTR capture and VTR output enter maintenance mode: they are no longer qualified or tested by Autodesk.

Keep in mind the following when selecting clips to use as logos:

If the clip has more than one frame, only the first frame is used.
If the clip is Burn™ pending, unlinked or unlinked HiRes, it cannot be used.
The higher the resolution for the clip, the more impact it has on the capacity of the application to output in real time.

Logo settings are persistent, and previous logo settings are loaded when you open the VTR Output module.

Note: The same logo, with its settings, is applied to all clips for which you have checked the Logo column in the VTR Output module list.

To insert a logo in real time:

Select clips from the Media List and select File > VTR Output...
In the VTR Output module, use the Logo column to indicate which clips are to be output with the logo.
Click the Logo tab to access the logo controls.
Select one or two clips to use as logo:

If you select one clip, it is used as the front clip and a luminance key is applied to it. If the clip has multiple frames, only the first frame is used.
If you select two clips, the first is used as the front and the second as the matte.

Use the logo controls to position and configure the appearance of your logo, and to define in and out points. See About the Logo Controls.
Output the clip.