Manipulates the layout of UVs as a group by letting you create a lattice around the UVs for deformation purposes.
To open the Lattice Tool, select it from the section of the UV Toolkit or select from the UV Editor menus.
The following options appear in the
Tool Settings window when you select
Tools > Lattice > 
.
Lattice Settings
- Columns
-
Specifies the number of columns for the current lattice manipulator. The minimum number of columns is 2 and maximum number is 8.
- Rows
-
Specifies the number of rows for the current lattice manipulator. The minimum number of rows is 2 and the maximum number is 8.
- Falloff
-
Specifies the lattice manipulator's level of influence or falloff value.
- Use Bounding Rectangle
-
When on, the current lattice manipulator cannot extend past the outer edge or boundary of the target geometry.
- Show move manipulator
-
Specifies whether to show the Move Tool manipulator when selecting lattice points
Snap Settings
The lattice snap settings are relative to each UV affected by the lattice. Pixel Snap () needs to be on in the UV Editor for the UV Lattice Tool Snap Settings to have any effect.- Placement
- Select where control points snap to.
- Snap Corner
-
When on, the UV lattice deformer’s control points snap to the corners of each UV.
- Snap Center
-
When on, the UV lattice deformer’s control points snap to the centers of each UV.