Check inspection sequence icons to verify the inspection.
Icons can appear on items in the inspection sequence when they have probe paths.
For Inspection groups, verification icons are displayed on the left of the group icon. The icon identifies the first fault in the group. For Geometric groups, verification icons are displayed on the left of items within the group. The icon identifies the first fault in the item's probe path.
Verification icons indicate the following:
The path contains no verification faults.
The path is unverified or probe path verification is disabled.
The collision check for the path is invalid.
The path contains a collision between the probe and the part.
Note: If a path contains a collision and an out-of-bounds move, only the out-of-bounds icon is displayed.
The path contains a missing contact.
Note: Missing contacts are not shown when Ignore Missing Contact Points is selected in the Options dialog.
The contact-point is too close to the start or end of the measure move, or the angle between the surface normal at the point of contact and the approach vector is greater than 80 degrees.
The path contains an out-of-bounds move.
The probe head or probe cannot be found.