Several snap modes are available to snap to useful points on raster entities.
- Center snaps to the center of a raster line. The entire width of the line must be in the snap window.
- End snaps to the end of a raster line.
Note: When a line ends because it intersects another line, this is considered an intersection, not an end point.
- Corner snaps to the intersection of 2 raster lines.
- Intersection snaps to the intersection of 3 or more raster lines. The entire intersection must be in the snap window.
- Edge snaps to the edge of a raster line. Any part of the raster line can be in the snap window.
Note: Raster Snap is active only when you are in a command and are being prompted for a point.