Showing 1-15 of 29 results for rotation (0.33 seconds)
-
Once you have created your nests, you can then also bind the shapes to their nesting properties ( rotation , deviation, increment). Binding is enabled by default, and Autodesk recommends leaving it on.
-
(You can also specify allowable orientations when setting up your nest later.) Rotation angles: Presets in 90 degree intervals.
-
Users reported that after applying the concentric cylindrical constraint, part rotation is limited in Inventor. It is unable to move parts in any direction after adding one constrain.
-
Users reported that it is not possible to select the centre of a Slot when placing a rotational Joint in Inventor. IncidentID: 28097 ArticleId:kA93g0000000hf7 ArticleNumber:000384263 DefectId:a0O3A00000IUjcYUAT
-
Users reported that after creating a sketch on the circular face, the whole model is rotating and the origin is in a different position.
-
Users reported that the Finish feature not supporting with adjust tool for appearance rotation in Inventor 2024. IncidentID: 71875 ArticleId:kA93g000000LLqU ArticleNumber:000533872 DefectId:a0O3g000006w9OaEAI
-
Users reported that when a miter cut is applied as end treatments between frame members in Inventor, the frame members are not mirrored correctly.
-
How can a Factory Asset be set to insert in a particular rotation around the assets Z axis in an Inventor Factory Layout?
-
Users reported that when trying to rotate the component in Inventor Assembly, similar components also start to rotate if they are connected as ' Rotational Joint'. IncidentID: 67176 ArticleId:kA93g000000TSvr ArticleNumber:000507955 DefectId:a0O3g000006b1XXEAY
-
Repair the sketches by closing the contours that are used for the rotation or extrusion. ArticleId:kA93g0000000R7l ArticleNumber:000321047
-
Users reported that after applying Rotational or Cylindrical joints with the Enter or Apply button - the selection of the next pair of origins does not work.
-
Users reported that when replacing a bolt from Content Center with the Lock Rotation option enabled in Inventor, the following message is displayed: Autodesk Inventor Professional - Replace Component The following errors occurred during command execution: Assembly1: Errors occurred during update The relationship was placed with respect to geometry that is no longer available.
-
While configuring rotational joints for door hinges in assembly project, it encountered persistent errors when applying both angular and linear limits.
-
Is free turning possible to get better results? Default rotation by 90 degrees, 180 degrees, and 270 degrees is possible in Nesting Default degrees are set to cut in sheet metal parts with specific grinding on the surface Rotation was set to default 90, and so on, to not have diagonal grinding on metal parts by accident.
-
In general, several factors influence the orientation or coordinate system of sketches: Default Option in Application Options - Look At Behavior "Perform Minimum rotation " is enabled by default: Inventor tries to avoid rotations of the sketch to match sketch orientation with the current view: "Rotates a minimum angle to make the sketch plane parallel with the screen, and the x axis of the sketch coordinate system either horizontal or vertical."
- 1
- 2
-
