First angle projection When you use first angle projection, projected views placed to the right of a base view depict the appearance when viewing it from the left.

The critical angle for which an object can be 3D printed without requiring supports.

How Override Tilt Angle works When you select Override Tilt Angle and specify a Preferred Angle , the preferred angle you specify is measured from the Tool Axis Reference.

Learn how to use the Plane At Angle tool to create a construction plane at a specified angle relative to a linear edge or axis in Fusion.

Offset Distance Offset (Align): Enter a distance value to offset between the selected geometry. Angle Offset ( Angle ): Enter the angle value for the relative angle between the selected geometry.

Usually determined in printer settings by adjusting the Support Maximum Angle . By default, the value of the overhang angle is 45°.

The defining parameter for the Pencil operation is the Bitangency Angle . Fusion runs the tool along all paths where it would be making two simultaneous contacts with the part with more than this angle in difference.

Enter a Minimum Tilt and Maximum Tilt angle to limit the tilting angle of the tool axis.

You specify a range of draft angles , and Fusion colors the body to indicate draft angle changes relative to that range.

Concentric: Positions selected geometry, so their center axis or center point are aligned. Angle An Angle Constraint positions the components so that their selected geometries are at a relative angle to each other.

Modify the height, angles , and size of a door stop. Before modifications (left) and the finished, enlarged example with an extruded body, angled top and sides, and internal supports (right).

Range: 0.00-1.00 Taper Angle Specify angle to taper the sweep.

Enter 15 deg in the Angle box to apply angles to the selected faces.

Modify the height, angles , and size of a door stop. Before modifications (left) and the finished, enlarged example with an extruded body, angled top and sides, and internal supports (right).

Specifying the slope angle From Slope Angle Only areas where the slope angle from horizontal is larger than this are machined.