- On the ribbon, click
Sketch tab
Draw panel
Line
, or right-click and select Line from the marking menu. - In the graphics window, move your cursor into the center of the construction circle previously projected. When the green dot appears, indicating that you have located the center of the projected circle, click to place the first point of a line segment:
- Paying attention to the vertical and horizontal constraint indicators, place a vertical and a horizontal construction line segment by selecting two additional points. Your profile should appear as follows:
- Click
Sketch tab
Constrain panel
Dimension
or right-click and select Create Dimension from the marking menu Then, place a horizontal length dimension of 85 mm that defines the distance between the guard mounting holes.
- Continue by placing a vertical dimension of 8 mm between the bottom edge of the guard and the horizontal construction line:
- Click
Sketch tab
Format panel
Construction
to reset your geometry creation to normal geometry.
- Click
Sketch tab
Draw panel
Point
.
- Place three sketch points at the ends of the two construction line segments.
- Click
Sketch tab
Exit panel
Finish Sketch
, or right-click and select Finish 2D Sketch to exit the sketch environment.
Note: You can optionally continue to work with a hidden edge display. The remaining illustrations in this tutorial show a shaded display. To return to a shaded display, click
View tab
Appearance panel
Shaded
from the drop-down menu under Visual Style.
Appearance panel
Shaded
from the drop-down menu under Visual Style. 
Now that you have sketched Center Points, you will next place two different-sized Punch features to provide clearance for the pin and holes for mounting screws.