Change Fan State and Displays

Create a nailboard view of the harness assembly from an open drawing, and change the fan state and display behavior.

1. Click New.
2. In the Create New File dialog box, click the Templates folder and select Standard.idw under the Drawing category, and click Create.
3. On the ribbon, click Place Views tab Create panel Nailboard.
4. On the Nailboard View dialog box, ensure that the File is set to Enclosure Assembly.iam and Nailboard View is Harness Assembly2.iam.
5. Click the Display tab, and select Fan In.
6. Under Appearance, click Display as Longest Wire.
7. Click OK to create the nailboard view.
8. Right-click and select Finish Sketch for a better view of the cable wire stubs.
   
9. On the ribbon, click Nailboard tab Edit panel Edit .
10. In the browser, right-click Harness Assembly2, and select Nailboard Settings.
11. On the Nailboard Settings dialog box, click Display as Segment in the Fan In Display area.
12. Click OK.
    
    Note: This technique is the only way to change the fan in the display once the nailboard drawing is created.
13. Close the drawing file without saving changes.

Previous | Next