Table dialog box

The Table dialog box displays list of available fasteners for bolted connection insertion for specified parameters (thread diameter, standard, category, placement).

Access:

Ribbon: Design tab Fasten panel Bolted Connection and then click the Design tab. In the area on the right side, specify fastener, select it and click .

There are parts in your database meets the specified parameters but that vary in material, thread description, or size designation or example. These fasteners enable a fastener to be selected with specified parameters. Click a row to select a fastener. Click OK and your selection is inserted into the Design tab of bolted connection generator.

When there is only one fastener displayed, there is only one fastener within your database that meets the specified criteria (placement, thread type, diameter, Standard, Category). To select another fastener from Content Center, click in the Design tab.

Only columns where data for fasteners vary are displayed.

You cannot edit any fastener data in this dialog box. Edit the fasteners using the Content Center editor.

DANGER: Bolted Connection Generator does not know the condition or reason why you selected a fastener. In the Table dialog box, you might select a bolt because it has a specific material. When you change a diameter value, the generator automatically selects a bolt that meets this new criteria but does not reflect the earlier change you made in the Table dialog box. To select a fastener with a specific material, select the fastener in the Table dialog box again.