Adds a chamfer on one or more part edges.
Access
Ribbon:
3D Model tab
Modify panel
Chamfer
Method
Specifies construction of the chamfer.
Distance -
Defines a chamfer with the same offset distance from the edge on both faces. Selects a single edge, multiple edges, or chained edges. You can specify corner setback appearance.
Distance and Angle -
Defines a chamfer by an offset from an edge and an angle from one face to the offset. You can chamfer any edge or all edges of a selected face at once.
Two Distances -
Creates a chamfer on a single edge with a specified distance for each face. You can chain edges together.
Edges and Faces
Selects one or more edges or faces. Press CTRL while clicking to remove geometry from the selection.
- Edges
-
Selects individual edges to chamfer, and previews default distance.
- Face
-
When a distance and angle define a chamfer, selects the affected face.
- Flip
-
When two distances define a chamfer, flips the direction of the chamfer distances.
Distance and Angle
Specifies the extent of selected chamfer method.
- Distance
-
Specifies offset distance of chamfer from selected edge or edges. When two distances define a chamfer, specifies both offsets.
- Angle
-
When a distance and angle define a chamfer, specifies the angle of the chamfer.
Edge Chain and Setback
If edges intersect at a tangent point, edge chain and setback appearance can be specified.
- Edge Chain
-
Selects all edges that share a tangent point.
- Setback
-
For the Distance chamfer method, defines corner appearance when three chamfered edges meet at a corner.
-
Chamfer can join at a flat intersection. -
Chamfer can form a corner point at the intersection, as if milled on three edges.
-