In this tutorial, you:
Created a project.
Imported a model.
Set the injection location.
Selected the material and started the analysis.
Reviewed results from the end gate location.
Moved the gate to the bottom edge.
Compared results between the two locations.
The end gate location has a good filling pattern, but the pressure is too high. The bottom gate location lowers the pressure to fill because the flow length through the part is shorter. The filling pattern is balanced, but a small change in the gate location makes the balance worse.
Be Adventurous
Look at more of the results for the analyses that are run.
Move the gate location and see how the filling pattern and injection pressure change.
Change processing parameters such as, mold temperature, melt temperature or injection time to see the influence on the injection pressure.