This help topic specifies the results generated for analyses that include Fill, Fill+Pack, or Standalone Pack analysis sequences.
These results are generated for material with or without fiber or filler content.
Before running an analysis, you should pay close attention to the edge length of the mesh around high curvature areas on your model, and make sure they are not too coarse. It is recommended you mesh with a smaller edge length allowing the mesh to approximate the corners correctly.
Text based results
The following table lists the text results that are created for each these analyses.
| Results |
|---|
| Analysis Log |
| Analysis Check |
| Machine Setup |
Graphical results
The following table lists the graphical results that are created and indicates whether each result is supported by the following analysis technologies:
Midplane 
Dual Domain 
3D
For more information about a result, including how to interpret the display, click on the result name.
Note: Overmolding results are available only if you are using an overmolding process. Thermoplastics overmolding analyses produce two sets of Fill analysis results, one for the first component and another for the overmolded component.
| 1 | This result is available only when the option to Perform venting analysis is selected in the solver parameters. |
| 2 | The Flow rate, beams result will appear in any Fill analysis where 1-dimensional elements are modeled. |