To modify an instance property of a wall sweep, you change the value of the corresponding parameter, as described under Modifying Instance Properties.
Common instance properties for wall sweeps are described below.
| Name | Description |
|---|---|
| Constraints | |
| Offset From Wall | The distance from the wall face. |
| Level | The level of the wall sweep. This property only appears for horizontal wall sweeps. |
| Offset From Level | The wall sweep’s offset from the level. This property only appears for horizontal wall sweeps. |
| Dimensions | |
| Length | The length of the wall sweep. This is a read-only parameter. |
| Identity Data | |
| Comments | Enter comments for the wall sweep. |
| Mark | A value to designate the particular wall sweep. This value must be unique for each wall sweep in a project. Revit warns you if the number is already used but allows you to continue using it. You can see the warning using the Review Warnings tool. See Reviewing Warning Messages. |
| Phasing | |
| Phase Created | The phase when the wall sweep was created. |
| Phase Demolished | The phase when the wall sweep was demolished. |