Use this dialog box to set and edit the mapping of targets in subassemblies to the names of actual objects in the drawing.
Displays the name of the corridor.
Displays the name of the assembly. If you are viewing the target for an entire corridor, for which there is more than one baseline, ‘**Varies**’ is displayed.
Displays the start chainage for the assembly’s region or the start chainage on the corridor baseline. If you are viewing the target for the entire corridor for which there is more than one baseline, ‘**Varies**’ is displayed.
Displays the end chainage for the assembly’s region or the end chainage on the corridor baseline. If you are viewing the target for the entire corridor for which there is more than one baseline, ‘**Varies**’ is displayed.
The properties table contains the following columns:
Lists targets that are required by the corridor’s subassemblies, categorized into three groups: Surfaces, Width Or Offset Targets, and Slope Or Level Targets.
Opens either the Pick A Surface, Set Width Or Offset Target, Set Slope Or Level Target or Select Pipe Network dialog box, where you can select the AutoCAD Civil 3D object name to map to the subassembly target.
Displays the name of the subassembly that requires the target.
Displays the name of the assembly group.