Curve Fit

This command creates a point curve fitted to points you select. The points can be part of previously created point curve and point surface objects, or they can be point sub-objects you created explicitly. They can't be CVs.

• Select a NURBS object. > Modify panel > Create Curves rollout > Dependent Curves group box > Curve Fit button
• Select a NURBS object. > Modify panel > NURBS toolbox > (Create Fit Curve)

Fitting a curve to selected points

Procedures

To create a point curve with Curve Fit:

The NURBS object must contain two or more point sub-objects.

1. In the NURBS toolbox, turn on (Create Fit Curve).
2. Click two or more points.

   A point curve is created. It runs through the points you select, in the order you select them.

   You can press to undo point selection in reverse order.

3. Right-click to end creation.

Interface

There are no parameters for a point curve created with Curve Fit.