Setting edge loads

When applying nodal loading conditions to a part, the node(s), direction of the load (force), and the magnitude of the load must be specified.

1. If the model nodes are not visible, turn on the appropriate layer in the Layers pane.
2. If you want to use a local coordinate system when setting the loads, first define and activate the local coordinate system.
3. Click (Boundary Conditions tab > Constraints and Loads panel > Loads > Edge Load).
4. Select the nodes on the model where you want to set the load(s), and enter the force to be applied (Nodal force) in the X, Y, and Z directions.
5. Select Apply. The load should now be applied to the model.
6. Click Close to close the dialog.

Tip: You can apply the load in any arbitrary (non-global) direction by first setting up a local axis system at the node (see Step 2). If a local axis system is not specified, the load will be set globally.