Superelevation Tab

Define how superelevation slopes are represented in the Preview panel. Superelevation can be previewed in Roadway Mode but not in Layout Mode.

Note: You can add superelevation-related parameters to a subassembly on the Input/Output Parameters tab.

Note: Select the ApplyAOR check box in the Properties panel for links to which you want to apply superelevation.

For more information, see About Defining Superelevation for a Subassembly.

Cross Slope	Specifies the superelevation cross slopes that are available as targets: Left Inside Lane Slope Left Inside Shoulder Slope Left Outside Lane Slope Left Outside Shoulder Slope Right Inside Lane Slope Right Inside Shoulder Slope Right Outside Lane Slope Right Outside Shoulder Slope
Preview Value	Specifies the slope at which the cross slope is represented in the Preview panel, relative to the reference point.
Enabled In Preview	Specifies whether to apply the Preview Value to the geometry that is shown in the Preview panel.