About Filtering by Location

You can filter or select data by specifying a location in your model.

When you specify a location condition in an expression, the Expression Editor switches to your model for you to draw the location manually. For example, if you want to find all buildings within a circular area, select the Spatial Within Circle condition to draw a circular location condition area on your model. Once you finish drawing the location condition area in your model, InfraWorks 360 switches back to the Expression Editor.

You can specify Disjoint , Intersects , Overlaps , Inside , or Within location conditions for a circular, rectangular, or polygonal area that you draw.
Location Condition Parameters Example

Disjoint

The boundaries and interiors do not intersect the given geometry (non-overlap).

Disjoint Circle selects all features non-overlapping a circle you draw.

Inside

The geometry is inside the given one.

Inside Polygon selects all features inside any part of a polygon you draw.

Intersects

The geometries have at least one point in common.

Intersects Rectangle selects all features intersecting a rectangle you draw.

Overlaps

The geometries have some points in common, but not all points in common.

Overlaps Polygon selects all features overlapping a polygon you draw.

Within

The geometry is completely within the given one, with no touching edges.

Within Circle selects all features within the circle, except for touching edges.

Note: Spatial conditions are not supported for tooltips or calculations.