Run a Progressive Fatigue Analysis

Learn the steps required to perform a progressive fatigue analysis.

To predict the cycles to failure for a composite structure in a finite element setting, you must first setup a progressive failure analysis using Helius PFA. The steps required to transform the static analysis into a fatigue analysis are minimal.

Material Definition

The current version of Helius PFA with progressive fatigue does not support material definitions within a GUI environment, and therefore the remainder of the discussion will center around directly modifying the input file to define a Helius PFA material for a fatigue analysis. Please refer to the Define a Helius PFA Composite Material section of this User's Guide before continuing with this section.

Specifying a material for a fatigue analysis is a direct extension of specifying a material for a static analysis. The main differences are listed below:

Temperature

In contrast to traditional Helius PFA analyses, you must specify the temperature of the analysis in absolute temperature units (Kelvin or Rankine) as an initial condition. This requires you to specify a temperature for all nodes in the model prior to applying any load. Refer to the Abaqus documentation for aid in specifying an initial temperature.

Specifying the Maximum Load

During the first cycle of the loading, the material could potentially undergo damage due to the static loads being applied. Therefore, the first step in the analysis should consist of loading the composite structure to the maximum load (over multiple load increments) in the prescribed load history.

Adding the Fatigue Step

After the maximum load has been applied to the structure and the static progressive failure analysis has been carried out, you must add a subsequent step in which the load is held constant. This step should consist of multiple increments and no prescribed thermal or mechanical loadings. Refer to the Specify a Load History for Progressive Fatigue section for more information.

Execution

Executing a progressive fatigue analysis is the same as running a conventional finite element analysis from the command line. Follow the instructions in this document for a detailed description of running an analysis with Helius PFA.

Note: The progressive fatigue feature is not supported for MPI (DMP) on Windows or Linux machines. Progressive fatigue can be run on a single Windows or Linux machine with any number of threads (SMP).