The Bubble pressure, final result shows the pressure of the gas inside the bubble at the end of the cooling phase.
This result is generated from a Microcellular injection molding analysis, for the following mesh types:
Midplane 
Dual Domain
Using this result
The Bubble pressure, final result is very useful for checking whether there are any pressure spikes. This is normally a sign of imbalance. Normally this can be fixed by changing gate location(s) or the amount of gas injected into the polymer. Sometimes only a subtle change is necessary.
Creating an XY Plot allows you to compare the final bubble pressure against the normalized thickness
Things to look for
- If the final bubble pressure is too high, warpage may occur. It is recommended that the bubble pressure be kept as low as possible.