To Drill the Four Holes

Repeat the Drill operation to create the four drilled holes.

1. On the ribbon, click CAM tab Drilling panel Drill .

Tool tab

1. Click the button to open the Tool Library.
2. From the CAM Mania Tutorial library, select #4 Ø0.0105" drill (#86).
3. Click to close the Tool Library dialog.

Geometry tab

1. On the Geometry tab, click the Hole faces button and select the bottom face of one of the threaded holes.
   
   
   
   
2. Enable the Select same diameter check box. The other three threaded holes are automatically selected.

Cycle tab

1. Click the Cycle tab. 
2. Select Drilling - rapid out from the Cycle type: drop-down menu.

Start the Calculation

1. Click the button, or right-click in the graphics window and select OK from the marking menu, to exit Drill and create the toolpath.

Continue to To Tap the Four Holes...