Specify sub-components to include with the Revit installation.
Note: This option does not apply to Revit LT.
By default, the sub-components are installed with the software. To omit an item from the installation, clear its checkbox. (You can install these items later, if preferred.)
The following sub-components are available with the current installation:
- FormIt Add-in (for converting files for use with FormIt)
- MEP Fabrication Configuration - Imperial (content for fabrication configurations using imperial units)
- MEP Fabrication Configuration - Metric (content for fabrication configurations using metric units)
The Sub-Components option is available as follows:
- During a stand-alone Revit installation, on the Install > Configure Installation page
- When creating a deployment, on the Create Deployment > Configure page (not available for
Revit LT)