To Create Pressure Networks from Objects

Create a pressure network from a selected object in the drawing.

This command converts lines, arcs, 2D and 3D polylines, splines, feature lines, alignments and survey figures into connected pressure pipes and bends.

1. On the Home tab, click Create Design panel Pipe Network Create Pressure Network From Object Find.
2. Select the object to be converted. Only one object can be selected.
   Note: Arcs are converted into curved pipe segments.

   Spline segments are converted into straight pipe segments connected with bends. If none of the available bend angles can be used, then the pipes are created without fittings to connect them.

   When converting an alignment that contains transitions, the transitions are converted into multiple curved pipe segments.

3. Accept the current direction or reverse the direction.
4. The Create Pressure Pipe Network From Object is displayed. Specify the following information for the pressure network:
   • pressure network name
   • pipe run name
   • parts list
   • size and material for the pressure pipes (parts will share the same material and nominal diameter)
   • layers
   • reference surface
   • whether to create a surface profile for the pressure network to follow
   • reference alignment
   • horizontal offset
   • level reference
5. Select Erase Existing Entity to delete the original object when the pressure network is created.
6. Click OK.
7. After the pressure network is created, you can use the Design Check command to identify pipes that exceed the allowable deflection or minimum flexible radius.

Ancillaries are not added when using this command.