Mark Parts without Number

This tool searches the entire model (depending on the Single Parts / Assemblies switch) for structural parts that do not have a part mark (e.g. because they were created after the numbering).

Note: Newly added objects only get detected if the switch is set to Single Parts ().

Access the command

In the Output tab Part marks panel, click (Mark parts without number).

Command line: _AstM5CommEqualPartsWithoutNum

Mark parts without numbers

1. In the Output tab Part marks panel, switch to the single parts:
2. In the Output tab Part marks panel, click (Mark parts without number).

• Any parts found are highlighted in red.