To Work With Creating Mesh Wedges

Create a Mesh Wedge Based on Diagonal and Height

1. Click Mesh Modeling tabPrimitives panelMesh Wedge. Find
2. Specify the first corner of the base.
3. Specify the opposite corner of the base.
4. Specify the height of the wedge.

Create a Mesh Wedge Based on Length, Width, and Height

1. Click Mesh Modeling tabPrimitives panelMesh Wedge. Find
2. Specify the first corner of the base.
3. At the Command prompt, enter L (Length). Specify the length of the base.
4. Specify the width of the base.
5. Specify the height of the wedge.

Create a Mesh Wedge With Equal Length, Width, and Height

1. Click Mesh Modeling tabPrimitives panelMesh Wedge. Find
2. Specify the first corner or enter c (Center) to set the center point of the base.
3. At the Command prompt, enter c (Cube). Specify the length of the wedge and a rotation angle.

   The length value sets both the width and height of the wedge.

Create a Mesh Wedge Based on a Center Point, Corner of Base, and Height

1. Click Mesh Modeling tabPrimitives panelMesh Wedge. Find
2. At the Command prompt, enter c (Center). Specify the center point of the base.
3. To set the location of a corner of the base, use one of the following methods:
   • To set the length and width simultaneously: Specify the location of one corner of the base.
   • To set the length and width separately: At the Command prompt, enter L (Length) and specify the length. Then specify the width.
4. Specify the height of the wedge.