If you have a mesh that's shaped to your liking but has bad topology (uneven faces, n-gons, etc), you can use the
Remesh and
Retopologize commands to fix the entire mesh and avoid painstaking manual modeling labor. Use this method when you want to uniformly retopologize an entire mesh at once.
Each of these commands can also be run individually, though they are typically run in sequence.
To retopologize a mesh
Note: If your scene file includes a
polyRetopo node prior to Maya 2020, you should delete history on your mesh before performing the following steps.
- Select the mesh.
- Change to the
Modeling menu set.
-
Prepare the mesh for
Retopologize.
- Select
.
- Enable
Keep Original if you want to preserve the original mesh as a backup.
- Enable
Preserve Hard Edges if you want to maintain the features denoted by hard edges on the retopologized model.
- For organic surfaces: The default settings are ideally tuned for organic surfaces.
- For hard surfaces: Set high
Topology Regularity and
Face Uniformity values (i.e. 1) with a low
Anisotropy value (i.e. 0).
This will convert all the faces of the mesh into 4-sided faces (quads).
Note: This operation may take a long time if you're working with a very dense mesh. You can view
Retopologize's progress in the
Output window. To cancel the operation, hold the
Esc key before
Retopologize finishes.
- (Optional) You can modify the settings in the polyRetopo node to adjust the result mesh. However, each change you make to an attribute will cause the algorithm to run again, unless you turn the node's
Pause button on first. We highly recommend turning this on, making multiple changes, then turning it off to see all those changes reflected at once..
-
(Recommended) Once the topology looks good, we highly recommend immediately deleting the object's history ().
Note: Ignoring this step will likely result in
polyRetopo executing again upon further mesh operations or when opening the file again, which can take a long time for dense meshes.
- (Optional) To transfer UVs from the original mesh to the retopologized one, select the original mesh and then the retopologized one and go to
.