Flowline finishing

Use the Flowline finishing page to create a toolpath from an embedded pattern. The pattern must contain several segments, typically two drive curves and two limit curves.

Curve definition specifies the curves bounding the area you want to machine and adds the machining properties to those curves.

Selected pattern — Select a pattern from the list. If no pattern is displayed, or is selected, then no pattern is selected. The list contains a list of all available patterns. Since flowline toolpaths are created from embedded patterns, only the embedded patterns are listed here.

Select picked pattern — Click to select a pattern by picking in the graphics window, rather than by name in the Select pattern list.

Clicking displays the Pick Entity tab. Select a pattern in the graphics window to close the Pick Entity tab and display the pattern in the Selected Pattern field.

Curve definition — Specifies:

• the drive curves
• the limit curves
• any intermediate curves
• the machining strategy.

Status — Summarises the current status of the selected curves, and is updated automatically as curves are selected. You need to reselect curves if Valid is not displayed.

Sequence — Select the sequence of toolpath segments.

• None — The raster type movement is maintained.
• Out to In — The toolpaths are transformed from a raster-type movement to a constant -Z or spiral-type movement.
• In to Out — The toolpaths are transformed from a raster-type movement to a constant-Z or spiral-type movement.

Ordering — Select how to link each successive toolpath segments.

• One way — The tool can only cut in one direction.
• Two way — The tool can cut in both directions.

For more information, see Raster ordering.

Surface joining tolerance — Enter a value to disassociate the machining tolerance from the tolerance used to define what is a gap between surfaces. If the gap between surfaces is larger than the machining tolerance, PowerMill creates two toolpath segments. To ensure one continuous toolpath across a gap, use a larger Surface joining tolerance.

Tolerance — Enter a value to determine how accurately the toolpath follows the contours of the model.

Thickness — Enter the amount of material to be left on the part. Click the Thickness button to separate the Thickness box in to Radial thickness Axial thickness . Use these to specify separate Radial and Axial thickness as independent values. Separate Radial and Axial thickness values are useful for orthogonal parts. You can use independent thickness on sloping walled parts, although it is more difficult to predict the results.

Radial thickness — Enter the radial offset to the tool. When 2.5-axis or 3-axis machining, a positive value leaves material on vertical walls.

Axial thickness — Enter the offset to the tool, in the tool axis direction only. When 2.5-axis or 3-axis machining, a positive value leaves material on horizontal faces.

Note: To avoid too much material being removed, Thickness should be greater than Tolerance.

Stepover — Enter the distance between successive machining passes.

• Copy stepover from tool — Click to load the radial depth of cut from the active tool's cutting data. The radial depth of cut is measured normal to the tool axis.
• Edited — When displayed, shows value entered by you (or another user). Click to change this value to the automatically calculated value. Click to change this to the automatically calculated value.
• Stepover — Enter the distance between successive machining passes.

  If you enter a Stepover value then changes to .