Use manual segmentation to individually segment and fit surfaces to a mesh.
Plane — surface only
Cylinder
Cone
Sphere
Torus
Extrusion
Revolution — surface only
Shrink-wrap — surface only
Fit inside — Select this option to fit the primitive surface just below the inside of the mesh. |
Fit through middle — Select this option to fit the primitive surface as close as possible to the centre of the mesh. |
|
|
Fit outside — Select this option to fit the primitive surface just above the outside of the mesh. |
|
|
If you delete a surface before returning to the segmenter, its regions are freed.
If you undo, redo, or modify the mesh, the persisted data is lost. If this happens, the segmenter cannot remember the surfaces it produced.