Control the gap between the center mark and its centerlines.
Specify the Default Gap Between a New Center Mark and its Centerlines
- At the Command prompt, enter CENTERCROSSGAP.
- Specify a new value. You can enter any of the following:
- Relative value - any positive real number followed by
x.
- Absolute value - any positive real number
- ByLineType
Specify the Gap Between an Existing Center Mark and its Centerlines
- If the Properties window is not displayed, select any object. Right-click and select Properties.
- Select one or more center marks.
- In the Properties window, under Geometry, select Cross Gap.
- Specify a new value.